Homogenizer Emulsification Mixer
Product characteristics of dispersing emulsifier The dispersing emulsifying machine is made with advanced German technology and has a unique structure. The materials move at high speed in the gap between multi-layer rotors and stators, forming strong hydraulic shear and turbulence, dispersing the materials, and generating comprehensive forces such as centrifugal extrusion, grinding and collision, so that the materials can be fully mixed, stirred and refined to meet the ideal requirements. The pot cover is equipped with a lighting observation hole to keep abreast of the emulsification status of the products in the pot at any time. It is equipped with micro material inlet to facilitate the addition process of special essence. It is easy to operate and discharge the material from the bottom of the pot. It can directly enter the filling machine through the pipe for sub loading. At the same time, it can also dump the material for cleaning.
- Fast Delievery
- Quality Assurance
- 24/7 Customer Service
Product Introduction
Precautions for operation of dispersing emulsifier
1. due to the high speed of the homogeneous cutting head, it is not allowed to operate in the empty pot state, so as to avoid affecting the sealing degree after local heating.
2. the ground wire shall be reliably grounded to ensure power safety.
3. the homogenizer is reversed when viewed from top to bottom. After the motor is wired or does not need to be used again for a long time, it should be jogged for test run. The mixing frame is reversed when viewed from top to bottom. During commissioning, jog the mixer for trial run, and then let the homogenizer run when it is confirmed to be correct.
4. before each mixing start, it shall be inched to check whether the mixing scraping wall is abnormal. If any, it shall be eliminated immediately.
5. before mixing and vacuum pumping, it is necessary to check whether the pot is level with the pot cover, whether the pot mouth and filler mouth cover are tightly covered and reliably sealed; Always check the water volume of the vacuum pump water tank. Do not cut off the water when the vacuum pump is running!
6. before shutting down the vacuum pump, close the ball valve in front of the vacuum pump.
7. the vacuum pump can be started and operated when the homogenizer is sealed. If there is a special need to open the atmosphere to start the pump, the operation shall not exceed 3 minutes.
8. before any maintenance or cleaning, the equipment must be cut off from the power supply.
9. never put your hand into the kettle during equipment operation to prevent accidents.
10. in case of abnormal response during operation, stop the operation immediately, and start the machine only after the cause is found out.
Specification
Product Description
Certifications
Exhibitions
Hot Tags: homogenizer emulsification mixer, China, manufacturers, suppliers, factory, low price, made in China
